SKF P203 - Page 3

3
Appendix to Declaration of Incorporation in accordance with 2006/42/EC, Annex II, No. 1 B
Description of the essential health and safety requirements according to 2006/42/EC, Annex I, which have been applied and
fulfilled. Any essential health and safety requirements not listed here are not relevant to this product.
Table
1
Appendix to Declaration of Incorporation
Valid for P2x3 lubrication pumps
No.:
Essential health and safety requirement
Applicable:
Fulfilled:
1.1.1
Definitions
Yes
Yes
1.1.2
Principles of safety integration
Yes
Yes
1.1.3
Materials and products
Yes
Partially
1)
1.1.5
Design of machinery to facilitate its handling
Yes
Yes
1.1.6
Ergonomics
Yes
Partially
2)
1.2
Control systems
Yes
Yes
1.2.1
Safety and reliability of control systems
Yes
Yes
1.2.3
Starting
Yes
Yes
1.2.6
Failure of the power supply
Yes
Yes
1.3
Protection against mechanical hazards
Yes
Yes
1.3.1
Risk of loss of stability
Yes
Yes
1.3.2
Risk of break-up during operation
Yes
Partially
3)
1.3.4
Risks due to surfaces, edges or angles
Yes
Yes
1.3.7
Risks related to moving parts
Yes
Yes
1.3.9
Risks of uncontrolled movements
Yes
Yes
1.5
Risks due to other hazards
Yes
Yes
1.5.1
Electricity supply
Yes
Yes
1.5.6
Fire
Yes
Yes
1.5.8
Noise
Yes
Yes
1.5.11
External radiation
Yes
Yes
1.5.13
Emissions of hazardous materials and substances
Yes
Yes
1.5.15
Risk of slipping, tripping, or falling
Yes
Yes
1.6
Servicing
1.6.1
Machinery maintenance
Yes
Yes
1.6.2
Access to operating positions and servicing points
Yes
Partially
4)
1.6.4
Operator interventions
Yes
Yes
1.7
Information
Yes
Yes
1.7.1
Information and warnings on the machinery
Yes
Yes
1.7.1.1
Information and information devices
Yes
Yes
1.7.2
Warning of residual risks
Yes
Yes
1.7.3
Marking of machinery
Yes
Yes
1.7.4
Operating instructions/assembly instructions
Yes
Yes
1.7.4.1
General principles for the drafting of operating instructions/assembly
instructions
Yes
Yes
1.7.4.2
Contents of the operating instructions/assembly instructions
Yes
Yes
1.7.4.3
Sales literature
Yes
Yes
1) Not completely fulfilled: Hazards due to the lubricant used must be assessed by the operator on the basis of the
Safety Data Sheet (SDS) and, if necessary, protective measures must be taken.
2) Not completely fulfilled: The operator must ensure that the pump is integrated into the higher-level machine in such
a way that the pump can be operated and filled ergonomically.
3) Not completely fulfilled: The operator must protect the lubrication system against excessive pressure. For this
purpose, a pressure limiting valve with max. 350 bar opening pressure must be provided on each pump element.
4) Not completely fulfilled: The operator must ensure that the pump is integrated into the higher-level machine in such
a way that the pump can be operated without danger.