• Do not use more force than is needed. If the cardstock is cutting through about 90% of the cut, then
turn on Passes. Some cardstocks do better with a second pass at a lower force.
____________________
I calibrated the camera for print and cut but every cut is off by the same amount.
• The calibration can be tweaked using the procedure presented in Section 3.05.1
____________________
I calibrated the camera for print and cut and the cuts start off accurate but, by the end of the cut, there is a lot of
error.
• This is called “drift” and can sometimes be corrected by slowing the speed and making sure the cuts
aren’t so deep that the blade is causing some drag to occur.
• An alternative solution is to add intermediate registration marks. Refer to Section 3.06..
____________________
To Previous Page
Loading...
