Skyjack SJ16 - General MEWP Inspections

18
213558ADA
SJ12, SJ16
Section 1 – Scheduled Maintenance General inspections
1.5 General inspections
Do an inspection of the MEWP in this sequence.
WARNING
Do not operate a MEWP that does not function
correctly. Lock and tag the MEWP, and remove it
for servicing. Only a qualified service technician
must repair the MEWP. If you do not obey, there is
a risk of death or serious injury.
WARNING
Turn the main power disconnect switch to the
off position before you do the visual and daily
maintenance inspections. If you do not obey, there
is a risk of death or serious injury.
CAUTION
Make sure that the MEWP is on a firm, level
surface before you do the visual and daily
maintenance inspections. If you do not obey, there
is a risk of machine damage.
1.5-1 Service Bulletins (B)
Go to www.skyjack.com and use your machine’s
serial number to find related open service bulletins.
1.5-2 Annual Inspection (B)
Do a check on the machine’s service record to find
information about previous service performed.
1.5-3 Labels (B)
Refer to the operation manual for the labels. Make sure
all the labels are in the correct location, are in good
condition, and you can read them.
1.5-4 Limit switches (B)
Make sure the limit switches are correctly attached,
there is no visible damage, and the movement is not
obstructed.