Skyjack SJ16 - Lift Cylinder Replacement Procedure

132
213558ADA
SJ12, SJ16
Section 5 – Procedures Lift Cylinder Replacement
8. Raise the platform into position using the base
controls so the lower platform bolts can be
installed. Apply Loctite 242 (blue) to the threads
and install the lower 4 bolts. Torque to 30 ft-lb
(41 N·m).
Figure 68 Platform Lower Bolts Installation
9. Fully lower the platform.
10. Install the mast cover
Figure 69 Mast Cover Installation
11. Perform a full function test before putting
machine into service as outlined in 2.3
Specifications and Features - CE, AS of the
operating manual.
5.15 Lift Cylinder Replacement
CAUTION
A second person to assist will be required to
complete this procedure.
WARNING
Do not stand or pass under a suspended load.
To remove the lift cylinder from the machine, the
platform and mast assembly must be removed
first. Fully lower the platform and shut down the
MEWP before starting this procedure.
5.15-1 Extending Platform Removal
1. See 5.8-1 Extending Platform Removal for
platform removal.
5.15-2 Mast Assembly Removal
1. Remove the cover on the top of the mast.
Figure 70 Mast Top Cover Removal