SMA HM-20 - Setting the Device Selection

13 Visualization of the energy management
SMA Solar Technology AG
Operating manual 103HM-20-BE-en-19
13.6.2.2 Setting the Device Selection
In the Device selection area, you can select whether the complete system and/or individual inverters are to be
displayed in the large diagram and in the Details area. Moreover, you can select whether absolute or specific values
are to be displayed.
Selecting devices:
1. To display the values of the complete system, activate the checkbox Complete PV system in the area Device
selection.
2. To display the values of individual inverters, perform the following steps:
3. Select the area Device selection
☑ The area opens and the individual inverters are displayed.
4. Activate the checkboxes for the desired inverters.
Tip: If you activate the checkbox Select all devices, the checkboxes for all inverters will be activated.
Selecting the display type:
• In the area Device selection, next to Display type, select the desired option:
☑ Absolute: Shows the system yield (kWh) or the system power (kW).
☑ Specific: Shows the specific system yield (kWh/kWp) or the specific system power.