SMA HM-20 - Configuring Reports

14 Monitoring of the SunnyHomeManager system
SMA Solar Technology AG
Operating manual 109HM-20-BE-en-19
Input field or drop-
down list
Explanation
Status In the drop-down menu you can either call up all messages or just the ones that are new or
that you already read:
• Not approved messages: new
• Approved messages: read
• all
In the table, the status is displayed in the Confirmed column with the corresponding symbol.
System/Devices The portal, the system and all devices of your system are listed in the drop-down list.
• To display the messages in SunnyPortal, the SunnyHomeManager system and the
devices, select All.
• To only display messages of a specific product, select the respective product (e.g.
SB4.0-1A-41).
The selected product can be found in the column PV system/Devices in the table.
Confirming messages:
Requirement:
☐ You must have the user role Installer or PV System Administrator (see Section16.1, page114).
1. To confirm individual messages, select in the required message line and the column Confirmed.
2. To confirm all messages check the checkbox Confirm all above the table.
14.2.6 Configuring Reports
Requirement:
☐ You must have the user role Installer or PV System Administrator (see Section16.1, page114).
You can configure different types of event reports, each with different content:
Report, type Possible content
3 x daily info report
3 x monthly info re-
port
• Yield (kWh) in the selected time period
• Maximum power (kW) in the selected time period
• CO
2
avoided (kg) in the selected time period
• Feed-in tariff in the selected time period, if applicable
• Diagram of the page Energy balance for the selected time period (only with PDF
delivery)
3x event report • Information
• Warnings
• Disturbances
• Error
1x event report for
standard
Message regarding grounding errors, residual current and the grid disconnecting device
• AS 5033
• DIN EN 62109-2 / IEC 62109-2
In addition, you can create a report for a specific date in the past.