3.4.4 Active Controls
When you control a dynamics parameter using the active encoders, the active controls are mapped to
the most recently adjusted parameter. The fine active control allows more precise control over the
parameters while the active pot helps you with quick adjustments. The active button turns the dynamics
bypass on or off.
3.4.5 Channel Encoder
Touching an active encoder or an active encoder display not only maps the parameter to active controls
but also maps the same dynamics parameter from each work channel to it's corresponding channel
encoder. If there is no dynamics plugin on a channel, it's encoder will not be mapped to anything and
the channel encoder display will be blank.
Operation Manual – Tango Smart Console 19
To Next Page
Loading...