5.1.5 Smart Locators
The transport section features five smart locators buttons. The smart locators are designed to give you
instant access (one button press) to the most important locations in your project. They store can store
and recall the DAW's timecode locations.
In order to store a timecode location press down one of the locators and hold it until the button lights
up. The timecode location at which the button was first pressed is now stored into that button. In order
to jump to the timecode location press and release the smart locator button. If you are in play, the
transport will continue to play after relocating, in any other mode, the transport will stop after locating.
Five addition smart locators can be accessed by holding down the smart touchpoint.
5.1.6 Timecode
Above active channel display there's a SMPTE timecode display indicating the DAW's locators
position in the project timeline.
Operation Manual – Tango Smart Console 27
To Next Page
Loading...