solo clear touch point at any time to abort the group creation and exit group mode.
6.5.2 Updating the Relationship Between Fader Levels
Sin order for you to adjust a relationship between the fader levels siimply touch and hold any one fader
belonging to the group and then adjust any other fader in the group. As long as more than one fader in
the group is touched, you can adjust the fader relationships at will. You do not have to be in a group
mode to do so.
Note: automation received from the workstation will also adjust the fader relationships; this allows
individual faders to “break” the group relationship using automation.
6.5.3 Grouped Channels Status
Press the group button to go into group mode, the UPO indicators on the MonARC are lit of all
members of all groups. To exit group mode press the group button again or touch solo clear.
Touching either a grouped fader or MonARC channel after entering group mode, will select that group
as “active”. The UPO’s will now only show members of that group. To select a different group, exit and
re-enter group mode and select the desired group.
6.5.4 Add/Remove Members
Once a group is selected press either the +group button to add members to the group or the – button to
remove members from the group. The button will light up to indicated the mode you are in. Once in
group add or remove mode, simply touch any fader or a MonARC channel to add or remove this
channel from the group. You can change back and forth between add and remove modes simply by
pressing the +group and –group buttons. Once you are happy with the members of the group press the
group button to exit the group mode.
6.5.5 Temporarily Disabling Grouping
At any time when not in group mode, pressing and holding the – group button will disable all groups.
This allows individual moves (either automated or real-time). When the button is released one of two
things will happen.
If you are holding a grouped fader, the rest of the faders in that group will instantly snap to their
positions relative to the held fader. Or, if you are not holding a grouped fader, any moved faders will
return to their grouped positions. To escape group mode discarding any changes simply touch solo
clear.
6.5.6 Mute and Solo Groups
Grouping other elements in the console follows all of the same rules described above for faders. The
only difference is that you must tell the console what elements it should be grouping.
Enter group mode by pressing the group button, then tap the first fader, mute or solo button you wish
to group. This changes the grouping mode to either faders, mutes or solos. To change to a different
grouping mode, exit and reenter group mode and then touch the type of control you wish to group
(fader, mute or solo).
Next time you enter group mode, you will have the last selected group mode. So if you grouped mutes
last time, you will be in mute grouping mode. Tango does not currently have a group mode display
indicator.
Operation Manual – Tango Smart Console 33
To Next Page
Loading...