while you wiggle it!). You can store more than one parameter, just keep your finger on the memory
button and touch all the parameters you'd like add to memory. Then paste them as usual by touching a
MonARC channel or inject point!
Note that in order to store routing values simply touch mix and group buttons of the active channel
while holding down the memory modifier. Only the states of the touched output destinations will be
stored and pasted onto a target channel.
6.7 Solo Modes
In Solo Section there are three buttons switch between solo modes, pfl (pre fade listen), afl (after fader
listen) and sip (solo in place).
6.7.1 Supported Modes
Pro Tools only supports solo in place mode, hence the sip button is permanently lit.
Operation Manual – Tango Smart Console 36
To Next Page
Loading...