HRX-MM-N007
Chapter 4 Service Procedure
HRS Series 4.5 Replacement Procedure
Mounting
1. Install the tank.
2. Mount the hoses and tank to the tank. (4 pcs.)
Fig. 4.5-26 Hoses attaching
3. Put the level switch cable [LS1] (2pcs.) through the grommet. Insert the pin to the
connector.
(No.2 & No.13)
Fig. 4.5-27 Location to mount the connector
[Tips]
It does not matter which connector [LS1] is mounted to which socket.
4. Mount the upper panel, the panels on both sides and the front panel in reversed order of
removal.
5. Mount the tank lid.
To Next Page
Loading...
Need help?
General
