HRX-MM-N007
Chapter 3 Alarm Indication and Troubleshooting
3.2 Error Type and Alarm Set Value HRS Series
3.2.1 How to reset alarm
The troubleshooting method depends which alarm has been generated.
Refer to’’ Table 3-1 ’’.
This page explains how to reset the alarm signal condition after eliminating
the cause of the alarm.
1. Ensure that the alarm display screen is displayed.
Alarm can only be reset on this screen.
2. Press [▼] and [▲] keys down simultaneously.
3. The alarm is reset.
The [ALARM] lamp goes off.
The operation panel displays the circulating fluid temperature and the circulating fluid set
temperature.
The contact signal of the contact input/output communication stops.
(Refer to the Operation Manual for communication for details.)
Fig.3.2-1 Alarm reset
To Next Page
Loading...
Need help?
General
