SMC Networks HRS012-A-10 Series User Manual

HRX-MM-N007
Chapter 4 Service Procedure
4.5 Replacement Procedure HRS Series
4-56
 Removal (Between tank-heat exchanger)
1. Discharge the circulating fluid referring the 4.2.2 Discharge of the circulating fluid and
facility water.
2. Remove the upper panel and the side panel on the left referring the 4.2.1 Removal and the
mounting of the panel.
3. Remove the hose clamp on the tank side. (2 locations)
4. Remove the tank.
5. Remove the hose clamp on the heat exchanger side and remove the hose.
Fig. 4.5-41 Removal of plastic hose (Between tank-heat exchanger)
 Mounting (Between tank-heat exchanger)
1. Mount the hose on the tank using the hose clamp.
2. Install the tank.
3. Mount the hose on the heat exchanger.
4. Hold the hose with the hose clamp. (3 locations)
5. Mount the upper panel and the side panel on the left in reversed order of removal.
2. Hose clamp
2. Hose clamp
2. Hose
2. Hose
Tank
Heat exchanger
Check the hose is not twisted after connecting.

SMC Networks HRS012-A-10 Series Specifications

General

Brand	SMC Networks
Model	HRS012-A-10 Series
Category	Chiller
Language	English