User Manual |
151
CNC Carving - 04 How to CNC Carve
Ensure that all clamp sets will not impede the movement of the machine and CNC bit in any axial
direction. Otherwise, the machine or CNC bit will bump into the clamp sets.
Use Screws
Screws provide secure and flexible xing for your material, while being fast and cheap. However, note that this xing
approach will damage the surface of the CNC Carving Platform.
Here are the steps:
(1) Place your material (no thicker than 50 mm) on the center of your CNC Carving Platform.
(2) Drill four holes into the corner of the material using an electric screwdriver.
(3) Put four screws into the four holes. Drill the screws down through the material and then into the CNC Carving
Platform using the electric screwdriver. Note that the screw should be long enough to penetrate the material.
Do not touch the electric screwdriver bit immediately after drilling; otherwise, you will be burnt.
To Next Page
Loading...
