User Manual |
170
CNC Carving - 06 Maintenance
To avoid this, you should check the vents and dust-proof nets monthly. Use a swab or vacuum to clean the foreign
matters.
6.3.3 Check the Nuts in the CNC Carving Platform
Check if any nut is screwed out of the CNC Carving Platform. If so, follow these steps to glue it back:
Before operation, wear protective gloves to prevent contact with the toxic AB glue. Wear our provided
mask to avoid inhaling the volatile, toxic gases. Do not misuse the A glue lid on the B one.
(1) Clear the sawdust on the nut.
(2) Squeeze out the A glue and B glue in a 1:1 proportion.
To Next Page
Loading...
