User Manual |
6
Safety Guidelines - Labels on Your Snapmaker
On the CNC Module
Warns you of sharp objects. Take care to avoid injury when attaching or detaching the CNC bits.
On the Heated Bed
Warns you of danger. Pay attention to any operations on the Heated Bed.
Warns you of the hot surface. Avoid direct contact with the Heated Bed during printing or immediately
after printing. Wait several minutes before contact or use auxiliary tools like heat-insulated gloves.
Do not print directly on this surface; otherwise, you will damage the Heated Bed.
Do not touch the Heated Bed with bare hands during printing or immediately after printing.
There are no labels on the Heated Bed on Snapmaker 2.0 A150. Nevertheless, you should remain
cautious in operation.
To Next Page
Loading...
