19
License Mode: This is where license keys can be entered to enable optional functions.
Tools Mode: This is where site survey and bulk install functions are configured.
Each is described individually in more detail below.
Normal Mode
Sending a Message
Send a message to your pager as follows:
1. Turn on the MAXPage unit.
MAXPage 11:30AM
Pager ID:[ ]
2. Enter the Pager ID. (0000-9999)
NOTE: The number of digits of which the Pager ID is made up, can be altered in the Windows software and in
Config Mode described below. If you enter a Pager ID less than that number of digits, you need to press the
or key to move to the next field. When a Pager ID is entered with the same number of digits as the programmed
maximum, MAXPage automatically moves you along to the next field or sends the message if it is a tone-only type.
Message:
[ ]
3. If you have entered a Pager ID for a numeric, alphanumeric, or voice pager, MAXPage prompts you for a
message to send. Use the keypad to type this in and confirm the entry with the key. To clear the
screen at any time, use the key.
NOTE: If you have entered a Pager ID for a tone-only pager, you are not prompted for a message. The page is
automatically sent and you are returned to the Main Screen.
NOTE: If the button is used to send a message to a POCSAG pager, the message is sent with the default beep
code setup on the unit. (See the Database Setup section later on). Alternatively the function keys can be used as
SEND buttons at this stage. Button forces the message to be sent with a beep code “A”. Button forces the
message to be sent with a beep code “B”. Button forces the message to be sent with a beep code “C”. Button
forces the message to be sent with a beep code “D”.
4. Once the details have been entered correctly, the page is sent, and the LCD confirms this by display
Message Sent as shown below:
Message Sent.
To Next Page
Loading...