General Operation Installation & Configuration Guide for MAXPage
page at regular intervals that the coaster pager can then lock onto. If the coaster pager misses a heartbeat page, it can
warn the user, by emitting a vibration or beep, telling them that they are out of range of the transmitter.
NOTE: MAXPage sends out heartbeat pages as tone-only messages.
Antitheft Mode (a.k.a. out-of-range mode) is where this very useful function can be setup. Before this function
operates correctly, you need to enable out-of-range mode on the coaster pagers themselves and take note of the cap
code used for this function.
1. To configure Antitheft Mode press from the Misc Menu. The following screen is shown. Press any
key on the keypad to choose between Y or N. (Yes or No).
Antitheft on [Y]
2. Press the key to move along to the next field.
a. If you selected N, you are taken back to the Configuration Menu screen.
b. If you selected Y, you see the screen below. The first field for editing is Capcode. Enter in the cap
code the heartbeat page should be sent out on here.
3. Press the key to move along to the next field. These details are supplied with the coaster system. The
valid cap code range is 0000008 – 2097151.
Capcode[ ]
Interval [ ]
4. The next field along is Interval. Using the keypad, enter in a time between heartbeat messages here.
NOTE: For the Patron Pager coasters, an interval of 30 seconds is suitable.
5. Press the key to save settings and return to the System Menu screen. The screen below is briefly shown
to confirm settings have been saved.
Hrtbeat saved
6. To return to Normal Mode, press the key four times to exit out of all menus. MAXPage restarts and is
ready for use.
Password
This section allows you to add, edit and remove passwords for MAXPage. Below shows where the passwords are
used and their default settings.
Maint: Used to enter Config Mode, Tools Mode, and License Mode. (Default – 123456)
Admin: Used to enter User Mode. (Default – not set)
NOTE: Passwords must be a full six characters long when entered into MAXPage. The Maint and Admin passwords
cannot be the same.
1. To select Passwd press from the Misc Menu. The following screen displays.
To Next Page
Loading...