43
Maint [123456]
Admin [ None]
2. The Maint password is the first field that can be edited. Type a new password using the keypad if required.
If you do not wish to change this password or have finished entering the new one, press the key to move
along to the next field.
3. The Admin password is the next field. Type a new password using the keypad if required.
4. The password can be set to NONE (you are not prompted for a password) by pressing the key.
5. If you do not wish to change this password or have finished entering the new one, press the key to save
changes and return to the System Menu.
6. The following screen is briefly shown to confirm the new passwords have been entered.
Passwords Saved.
7. To return to Normal Mode, press the key four times to exit out of all menus. MAXPage restarts and is
ready for use.
ID[?]
This setting is used to set the Pager ID length when MAXPage is in Normal Mode. This is useful to limit
the number of digits the Pager ID can be.
1. To select ID[?] press from the Misc Menu. The following screen displays.
ID length [4]
2. Using the numeric keypad, select a number between 1 and 4. Press the key to save changes and return
to the Misc Menu.
Keys
This menu allows you to setup the function keys.
1. Press from the System menu screen to view the Keys Menu screen.
1.Function Keys
2.Alt Funct Keys
2. Here you can assign canned messages and Pager ID’s to the function keys and the alternate function keys.
When a function or alternate function key is pressed, the pre-programmed message is silently sent to the
specified pager or group. MAXPage has four function keys down the right hand side of the keypad.
3. These can also be activated on the PS2 keyboard (if installed) by pressing F1, F2, F3, or F4.
4. The alternate function key is activated by holding the key and then pressing the relevant function key.
To Next Page
Loading...