General Operation Installation & Configuration Guide for MAXPage
5. These alternate function keys can also be activated on the PS2 keyboard (if installed) by pressing F5, F6,
F7, or F8.
6. The programmed message is automatically sent to the programmed recipient when the function key is
pressed.
NOTE: The function keys can also be used to send different beep codes to the pagers. Refer to the Sending
Messages section above for more information.
F-Keys
1. To configure the Function Keys, press from the Keys Menu. The following screen displays.
Function Key [ ]
Msg[ ]
2. The first field for editing is Function Key. Using the keypad enter the Function Key number between 1
and 4.
3. Press the key to move along to the next field.
4. The next field is Msg. Enter the message that is sent when pressing the Function Key.
5. Press the key to move along to the next field.
6. The next field is Pager ID. Enter the Pager ID of the recipient that receives the message here.
7. Press the key to move along to the next field.
Pager ID: [ ]
Call Tone [A]
8. The next field is Call Tone. This refers to the beep code that sent with the message. Press any key on the
keypad to choose between A, B, C or D.
9. Press the key to save changes and you are returned to the Keys Menu.
10. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage then restarts
and is ready for use.
Beep
This menu allows you to enable or disable the beeper that normally sounds whenever a key is pressed on the
MAXPage keypad.
1. To select Beep, press from the Keys Menu. The following screen displays.
Key Beep [ON]
2. Press any numeric key on the keypad to choose between ON or OFF.
3. Press the key to return back to the Keys Menu.
4. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage restarts and is
ready for use.
To Next Page
Loading...