spok MAXPage - Espa; Transmitter

Installation & Configuration Guide for MAXPage Windows MAXPage Software

67
ESPA
Lookup
Local
ID
Placing a tick in this box means that ESPA messages must contain
a Pager ID. MAXPage looks up the Pager ID within its internal
database and send the message to the appropriate recipient. Un-
ticking the box means that the ESPA message must contain a cap
code. MAXPage sends the message to the cap code specified.
Transmitter
POCSAG Data Rate
Where you select the baud rate of the POCSAG data, sent out from the transmitter. This
must match the receiving device (pager).
Default Beep Tone
The default beep code sent to the receiving device if no other beep code was specified.
Ignore Busy
Used to enable or disable channel busy detection. If the tick box is not ticked, MAXPage
waits until the channel is clear before attempting to send the message. If the tick box is
ticked, MAXPage always attempts to send the message straight away. The MAXPage
must contain a transmitter capable of busy detection to take advantage of this feature.
Two Tone Duration
A & B
Specify the length of each of the two tones, when two-tone voice pagers are used. The
first tone is usually one second or less. The second tone is usually three seconds or less.
Consult the documentation that came with your voice pagers for the optimal duration
settings. The default settings are usually sufficient in most circumstances.
Two Gap Duration
Refers to the gap between the two tones. The default value of zero seconds is usually
sufficient for most voice pagers however some may need a small gap. Consult the
documentation that came with your voice pagers for the optimal duration setting.
System Encoding
Method
Only used when serial input from a COMP2 or TAP third party paging system is being
utilized and the Lookup Local ID tick-box on the Interface Communications tab is not
ticked. In this case, a raw cap code is being supplied within these protocol data, so there
is no way MAXPage can determine how to encode the message. This field sets the
default encoding method.
Voice Pager Type
Used to select the type of voice pagers being used at the site. See the documentation that
came with the voice pagers for more information.