41
2. Using the keypad, enter the Alarm ID you wish to delete.
3. Click the key.
Delete Alarm [ ]
4. You are prompted to confirm deletion. MAXPage shows the following screen. Pressing the key deletes
the Alarm ID details.
5. If you do not wish to delete that Alarm ID, press any numeric key.
Delete Alarm 1?
(Send confirms)
The LCD briefly display the following message to confirm the details have been erased.
Alarm 1 Deleted
6. Once deleted, you return to the Alarms Menu screen. To return to Normal Mode, press the key twice
to exit out of all menus. MAXPage restarts and is ready for use.
System
This menu is used to configure the out of range (aka anti-theft), passwords, the function keys and the beep on/off
setting.
1. The System Menu screen shown below. At the Config Mode menu screen, press to select System.
1.Misc 2.Keys
3.Canned Msgs
Misc
This menu allows you to setup the out of range feature (aka anti-theft), administer the MAXPage passwords as well
as set the pager ID length (PBX digit length).
1. Press from the Config Mode menu screen to view the Misc Menu screen shown below.
1.Antitheft Mode
2.Passwd 3.ID[?]
Antitheft Mode (Out of Range)
Coaster pagers (such as the Patron Pager) have the ability to listen and lock onto a special “heartbeat” known as an
out-of-range message. To enable this feature to work correctly, the transmitter is required to send out a heartbeat
To Next Page
Loading...