49
4. Press the key to move along to the Number of pagers field. This is the number of pagers that are
installed in the pager database.
Number of pagers
[ ]
5. Press the key to move along to the next screen. The first field on this screen is PagerType. This refers
to the type of pagers that are bulk installed.
6. Press any key on the numeric keypad to toggle between the various pager types.
PagerType[Coast]
Clear DB?[N]
7. Press the key to move along to the Clear DB field.
a. If [Y] is selected in this field, the entire database will be cleared to make room for the bulk installed
pagers.
b. If [N] is selected, the bulk installed pagers will be installed where there are free pager ID’s. For
example if there is currently Pager ID’s 1, 3 and 4 configured on the unit and then 3 pagers are bulk
installed into the unit – The bulk installed pagers will be set to Pager ID’s 2, 5 and 6.
8. Press the key to move along to the confirmation screen when ready.
NOTE: If you choose [Y] in this field and proceed with the bulk install, the entire database is cleared from the
MAXPage memory. This includes all pagers, groups, alarms, and reminders. Be sure to back up the database using
the Windows software if required.
9. The screen below is shown. Press the key to continue and save the pagers to the database.
10. If you do not wish to save the Pager ID’s to the database, press the key. You are then taken back to the
Tools Mode menu screen.
SEND to install,
DEL to cancel.
11. To return to Normal Mode, press the key once to exit out of all menus. MAXPage restarts and is ready
for use.
Changing the MAXPage Frequency, Power Level, &
Channel Spacing
1. Press the , , and keys simultaneously or by pressing F9 on the PS2 keyboard if installed. If the
password feature has been enabled, you have to enter this in before proceeding. This is the “Maint”
password (set to 123456 by default)
2. Once you are in Config Mode, there are four menu options:
To Next Page
Loading...