General Operation Installation & Configuration Guide for MAXPage
PBX Message [ ]
Msg[ ]
2. The first field is for the PBX Message ID. This is the ID number that correlates to the canned/PBX
message. Enter a number here between 0 and 9.
3. Press the key to move along to the next field.
4. The next field is Msg. This is the message that is sent to the recipient. Type the message here.
5. Press the key to save changes and return to the System Menu screen.
6. To return to Normal Mode, press the key twice to exit out of all menus. MAXPage restarts and is
ready for use.
License Mode
Entering License Mode
1. To enter License Mode while at the Main Screen, press the , , and keys simultaneously or by
pressing F11 on the PS2 keyboard if installed.
NOTE: If the password feature has been enabled, you have to enter this in before proceeding.
NOTE: This is the “Maint” password (set to 123456 by default)
Once you are in License Mode, you see a screen similar to below:
Lic[14598184674]
New[ ]
NOTE: The license key is longer than the screen width. Use to view the rest of the key while the Lic field is
selected.
2. The current license key is displayed in the Lic field. This contains highly encrypted information pertaining
to currently installed features in the MAXPage unit.
3. If you wish to add or remove features to the unit you need to obtain a new license key. Contact your place
of purchase for information on how to obtain a new license key.
4. A new license key is required if you wish to add or remove any of the following features:
PS/2 keyboard
Alarm inputs
RS232 interface
Telephone (PBX) interface
Two-tone Voice paging
5. When the new license key has been obtained it is entered into the New field. To jump from the Lic field to
the New field, press the key.
6. Enter the new license key, followed by the key.
To Next Page
Loading...