55
2. To find out which settings are currently in use by the MAXPage unit, see the Ports Menu section of this
manual. This information tells you the unit’s current data settings except for the COM port.
3. Click OK once the correct settings are chosen. To attempt to connect to the unit using these settings, click
File|Connect to MAXPage.
4. If the settings were correct and the software has successfully connected to the unit, the software displays the
following in the status bar.
5. If connection failed, the warning message below is shown. Double check all settings are correct and try
again.
6. Next time the software is started up, it attempts to connect to the MAXPage unit using the last settings it
stored.
Logging into the Software
Once you are connected to MAXPage, you must login to the software to modify system configuration. The password
that is required for configuration changes is the Maint Password. (Default = 123456). Choose File|Login and enter
the password when prompted. Once a valid password has been entered, all settings in the software are enabled and
ready for use.
For day to day usage when configuration changes are not required, or for users who are not authorized to have the
ability to change system settings, the admin password is available (Default = no password). This allows access to
message related settings – e.g. Reminders, Pager and Group configuration, common or PBX messages, and function
key configuration as well as the ability to send manual messages.
NOTE: It is recommended that you write down all passwords and store them in a safe place.
To Next Page
Loading...