MAXPage Installation & Configuration Guide for MAXPage
ROHS & WEEE
To minimize the environmental impact and take more responsibility for the world in which we live, Spok hereby
confirms that the following product series comply with Directive 2002/95/EC (RoHS) and 2002/96/EC (WEEE) of
the European Parliament.
SAA (AUSTRALIA)
To ensure compliance with ACA Technical Standards, this equipment is labeled with a Telecommunications
Compliance Label. For safety reasons, this equipment should only be connected to compliant telecommunications
equipment in accordance with the manufacturer’s instructions.
FCC (USA)
Part 15
This equipment has been tested and found to comply with FCC Rules and Regulations, Part 15 with the limits of a
Class B digital device, designed to provide reasonable protection against harmful interference. This equipment
generates, uses, and can radiate frequency energy and if not installed and used in accordance with the instructions,
may cause interference harmful to radio communications. On the base of the equipment is a label containing an FCC
Registration Number, if applicable.
Part 68
This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label that contains, among
other information, the FCC registration number and ringer equivalence number (REN.) If requested, this information
must be provided to the telephone company.
The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive
REN’s on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all areas, the sum of the REN’s should not exceed five (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total REN’s contact the telephone company to determine the maximum
REN for the calling area.
This equipment cannot be used on the telephone company provided coin service. Connection to Party Line Service is
subject to State Tariffs.
If this equipment causes harm to the telephone network, the telephone company notifies you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, the telephone company
notifies the customer as soon as possible. Also, you are advised of your right to file a complaint with the FCC if you
believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect
the operation of the equipment. If this happens, the telephone company provides advance notice in order for you to
make the necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact:
Company Name: Spok, 8301 Cypress Plaza Drive, Suite 105, Jacksonville, FL 32256-4416
Tel: +1 904 281 0073, Fax: +1 904 281 0074
If the trouble is causing harm to the telephone network, the telephone company may request you to remove the
equipment from the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ11C
To Next Page
Loading...