EasyManua.ls Logo

ST ST32M103 Series - Page 318

ST ST32M103 Series
519 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Controller area network (bxCAN) UM0306
318/519
Receive FIFO mailbox data length control and time stamp register
(CAN_RDTxR) (x=0..1)
Address Offsets: 1B4h, 1C4h
Reset Value: xxh
Note: All RX registers are write protected.
Receive FIFO mailbox data low register (CAN_RDLxR) (x=0..1)
All bits of this register are write protected when the mailbox is not in empty state.
Address Offsets: 1B8h, 1C8h
Reset Value: xxh
Note: All RX registers are write protected.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
TIME[15:0]
rrrrrrrrrrrrrrrr
1514131211109876543210
FMI[7:0] Reserved DLC[3:0]
rrrrrrrr rrrr
Bits 31:16
TIME[15:0]: Message Time Stamp
This field contains the 16-bit timer value captured at the SOF detection.
Bits 15:8
FMI[7:0]: Filter Match Index
This register contains the index of the filter the message stored in the mailbox
passed through. For more details on identifier filtering please refer to
Section 14.5.4: Identifier filtering on page 291 - Filter Match Index paragraph.
Bits 7:4 Reserved, forced by hardware to 0.
Bits 3:0
DLC[3:0]: Data Length Code
This field defines the number of data bytes a data frame contains (0 to 8). It is 0 in
the case of a remote frame request.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
DATA3[7:0] DATA2[7:0]
rrrrrrrrrrrrrrrr
1514131211109876543210
DATA1[7:0] DATA0[7:0]
rrrrrrrrrrrrrrrr
www.BDTIC.com/ST

Table of Contents

Related product manuals