Steketee EC-WEEDER - Page 117

Fault description Cause Remedy
Lifting of the hoeing implement
is slow or not possible at all.
Two control units DW are sub‐
jected to continuous ow.
No pressure displayed on the
pressure gauge
Pressure has exceeded 70 bar. n
Have the error rectied by service
personnel.
Restrictor washer, line or valve
clogged.
n
Have the error rectied by service
personnel.
The hydraulic valves are defec‐
tive.
Oil quantity l/min is set too high. n Valves:
Have the error rectied by service
personnel.
n Set the oil quantity l/min to the per‐
mitted value (5...10 l/min).
The electrical connection
between tractor and operation
terminal is faulty.
The electrical lines are trapped. Stop the tractor. Disconnect electrical lines
and check for damage.
Have defective electrical lines replaced
by service personnel.
When driving with GPS, the
hoeing elements are not lifted
automatically as expected.
GPS signals are not transmitted
to the control because the
tractor is moving too slowly.
To transmit the GPS data to the hoeing ele‐
ments (Combi), the control requires a min‐
imum speed of approx. 3 km.
Troubleshooting and error correction
en-GB | Item no. 17513597 | BA 02/05-2022 111