The implement control is operated via an ISOBUS operation terminal,
e.g. LEMKEN CCI 1200.
LEMKEN ISOBUS operation terminal:
n LEMKEN CCI 50
n LEMKEN CCI 200
n LEMKEN CCI 800
n LEMKEN CCI 1200
An ISOBUS operation terminal can also be combined with additional
(AUX) input devices for the ISOBUS.
n Observe the operating instructions for the ISOBUS operation ter‐
minal.
n Observe the operating instructions for operating the control, e.g.
Section Control.
3.8.2 Operating menu of Section Control
The user can lift and lower the hydraulic hoeing elements with the
electronic control Section Control.
The electronic control consists of the following components:
n Job computer installed at the machine.
n Software installed on the job computer.
The software user interface is automatically loaded from the machine’s
job computer to the tractor’s operation terminal as soon as the
machine is electronically connected to the tractor.
The following applications are possible with the control:
n Manual steering of the hoeing elements via buttons in the oper‐
ating menu
n Automatic control of the hoeing elements using GPS
Ä
Chapter 6.2 ‘Basic operation’ on page 56
Ä
Chapter 6.3.7 ‘Setting menus of Section Control ’ on page 87
LEMKEN ISOBUS operation terminal
LEMKEN CCI 1200
Electronic control
Design and description
en-GB | Item no. 17513597 | BA 02/05-2022 39
To Next Page
Loading...