Steketee EC-WEEDER - Align Hoeing Implement Without Support Wheels

6.3.3 Align hoeing implement without support wheels
Hoeing implements without support wheels are aligned with the lower
links and top link of the tractor.
6.3.3.1 Adjust height of the toolbar
1. Lift the toolbar of the hoeing implement to the required height
using the rear hydraulics of the tractor:
n Basic-Elements: 50 cm ground clearance (with special versions
70 cm or 100 cm)
n Combi-Elements: 70 cm ground clearance
n TRS-Elements: 70 cm ground clearance
2. Saving setting.
6.3.3.2 Align tool holder and parallelogram
1. Move the hoeing implement to the horizontal working position
using the lower links.
2. Fix the depth limiter of the position control to the working height
of the hoeing elements (50 or 70 cm).
3.
Retract or extend the top link until the parallelogram
1
is aligned
exactly at a right angle.
ð
The tool holder
2
is horizontal and parallel to the ground.
1 2
1
Parallelogram
2
Tool holder
Operation
en-GB | Item no. 17513597 | BA 02/05-2022 72