4.
Set the same working depth for all hoeing elements.
Ä
Chapter
6.3.6 ‘Adjusting working depth of hoeing elements’ on page 85
5. Lower the implement in the working row.
6. Drive at a steady speed along the rows of crops. Observe the
hoeing elements while driving.
7. Lift the implement at the headland.
8. After the hoeing process: Clean and park the implement.
Dependence of the knife selection on the soil condition
High precision No stones
Rigid hoeing knife
and rigid L-blade
Hoeing knife and L-
blade on the vibro
holder
Duck-foot share
Low precision Lots of stones
Operation
en-GB | Item no. 17513597 | BA 02/05-2022 55
To Next Page
Loading...