4-1
Operating Instructions Operator Manual 920509-645
4.1 Before Operating
Washer
Become familiar with location and function of all major components
and controls of the Basil
®
4700 Cage and Rack Washer as well as
their function before operating equipment.
1. Verify building electrical supply disconnect switch (circuit
breaker) is positioned to ON. Verify steam and water supply
valves are open.
2. Open chamber door. Verify chamber is empty and all material
has been removed.
3. Verify debris screens in bottom of sump are clean and properly
installed.
4. Open printer door and check sufficient amount of printer paper
is available.
NOTE: A colored warning stripe is visible when printer paper roll
is near the end. Refer to S
ECTION 6.6, PRINTER PAPER ROLL
REPLACEMENT, if paper is needed.
5. If applicable, ensure manual drain valves on bottom of tanks and
acid detergent tank are closed (see Figure 4-1).
IMPORTANT: A listing of the Safety Precautions to be observed when operating this Cage and Rack
Washer can be found in S
ECTION 1. Do not operate equipment until you have become familiar with this
information.
Figure 4-1. Manual Drain Valves
Manual Drain valves
OPERATING INSTRUCTIONS
To Next Page
Loading...
