Steris Basil 4700 - 4.10 Pause a Cycle; 4.11 Abort a Cycle

4-15
Operating Instructions Operator Manual 920509-645
4.10 Pause a Cycle If operator needs to pause a cycle, washer operation can be halted
at any time by pressing STOP on touch screen. Once interrupted,
cycle either can be resumed or aborted.
1. To pause a cycle in progress, press STOP on touch screen.
Display shows:
RESUME OR ABORT CYCLE?
2. Press RESUME CYCLE on touch screen to resume cycle. Cycle
resumes at beginning of phase where cycle was interrupted.
4.11 Abort a Cycle If cycle needs to be aborted for any reason, proceed as follows:
1. Press STOP on touch screen. Display shows:
RESUME OR ABORT CYCLE?
2. Press ABORT on touch screen.
Figure 4-5. Resume or Abort a Cycle
Press to ABORT Cycle
Press to RESUME Cycle
Press STOP Touch Pad