Steris Basil 4700 - Replacing Detergent Container

6-14
920509-645 Operator Manual Routine Maintenance
6.5.5 Replacing Detergent
Container
To achieve maximum cleaning efficiency, select a chemical appro-
priate to soil type being processed. Refer to S
ECTION 2.3, CHEMICAL
ADDITIVES SPECIFICATIONS, and always follow chemical manufacturer’s
recommendations for amount of chemical to be used.
NOTE: Always use a non-foaming chemical for effective cleaning and
proper pump operation.
When chemical is low or has run out:
1. Remove pickup tube and level sensor assembly from empty
container and remove container.
2. Install a new container.
3. Insert pickup tube and level sensor vertically into new container.
WARNING – ELECTRIC SHOCK
HAZARD:
Disconnect all utili-
ties to washer before servic-
ing. Do not service washer
unless all utilities have been
properly locked out. Always
follow local occupational
health and safety regulations,
as well as electric and plumb-
ing codes.
WARNING – CHEMICAL BURN
AND/OR EYE INJURY HAZ-
ARD
: Washer detergents are
caustic and can cause
adverse effects to exposed
tissues. Do not get in eyes, on
skin or attempt to swallow.
Read and follow precautions
and instructions on detergent
label and in Material Safety
Data Sheet (MSDS) prior to
handling detergent, refilling
detergent container, or servic-
ing detergent injection pump
or lines. Wear appropriate
Personal Protective Equip-
ment (PPE) whenever han-
dling detergent or servicing
detergent injection pump and
lines.
CAUTION – POSSIBLE EQUIP-
MENT DAMAGE
:
• When choosing a deter-
gent, select one with a low
chloride content. Deter-
gents with a high chloride
content can corrode stain-
less steel.
• Always use non-foaming
chemical for effective
cleaning and proper pump
and water level control
operation. Follow manufac-
turer’s recommendations
for amount of chemical to
be used.
Figure 6-6. Replacing Detergent Container
Detergent Container
Supply Hoses
WARNING – CHEMICAL BURN AND/OR EYE INJURY
HAZARD: Wear appropriate Personal Protective Equip-
ment (PPE) when removing clamps and replacing
squeeze tubes. Residual chemicals might remain in
used squeeze tubes. If chemical contacts skin or eyes,
immediately flush with running water for at least 10
minutes. If contact was with eyes, seek medical atten-
tion.