7-1
Troubleshooting Operator Manual 920509-645
This section contains detailed information on types of washer mal-
functions likely to occur and possible causes and corrective actions.
If you are unable to correct the problem with use of the following
Troubleshooting Charts, or if a problem occurs that is not described
on chart, please call STERIS. A factory-trained technician will
promptly place your washer in proper working condition. Service
charges may be incurred. Consult your warranty for details.
NOTE: Never allow unqualified persons to service washer.
Table Descriptions
Table 7-1 - Troubleshooting Chart - Situations where NO alarm or
printout occur.
Table 7-2 - Fault Chart - Faults where alarm and/or printout occur.
IMPORTANT: A listing of the Safety Precautions to be observed when operating this Cage and Bottle
Washer can be found in S
ECTION 1. Do not operate equipment until you have become familiar with this
information.
WARNING – PERSONAL
INJURY AND/OR EQUIPMENT
DAMAGE HAZARD: Only
STERIS or STERIS-trained
service technicians should
make repairs and adjustments
to this equipment. Mainte-
nance done by inexperienced,
unqualified personnel, or
installation of unauthorized
parts could cause personal
injury, invalidate warranty, or
result in costly damage. Con-
tact STERIS regarding service
options.
WARNING – ELECTRIC SHOCK
HAZARD:
Disconnect all utili-
ties to washer before servic-
ing. Do not service washer
unless all utilities have been
properly locked out. Always
follow local electrical safety -
related work practice stan-
dards.
WARNING – BURN HAZARD:
Allow unit to cool down
before performing any service
on mechanical components
and on piping. Components
and piping become very hot
during operation.
TROUBLESHOOTING
To Next Page
Loading...
