Steris Basil 4700 - 5.2 Supervisor Mode

5-3
Cycle and Control Value Programming Operator Manual 920509-645
5.2 Supervisor Mode Supervisor mode access is secured by a password.
5.2.1 Supervisor Mode Menus Supervisor mode includes the following menus:
• Set Date – to set washer date
• Set Date Format – to select date format (YYYY/MM/DD, MM/DD/
YYYY or DD/MM/YYYY
• Set Time – to set washer time
• Set Temperature Format – to select temperature units (Celsius
or Fahrenheit)
• Modify Cycles (see S
ECTION 5.3, CYCLES MENU) – to create
customized cycles and modify customized and preprogrammed
cycles:
• To modify cycles name, icon
• To modify cycles phases parameters
• To reset cycle default parameters
• Printer – to enable or disable printer
5.2.2 Accessing Supervisor
Mode
To access Supervisor mode, proceed as follows:
1. On Mode Selection screen, press OPTIONS touch pad.
2. On Options screen, press SUPERVISOR MODE touch pad.
3. On Numeric keyboard, enter appropriate password (supervisor
and service user can access Supervisor Mode).
4. Press OK touch pad.
NOTE: If password entered is wrong, display shows:
USERNAME OR PASSWORD NOT RECOGNIZED, PLEASE
TRY AGAIN.