Steris Basil 4700 - CYCLE AND CONTROL VALUE PROGRAMMING; 5.1 General

5-1
Cycle and Control Value Programming Operator Manual 920509-645
5.1 General PLC control of Basil
®
4700 Cage and Rack Washer allows adjust-
ment of previously programmed cycles to process different types of
loads.
Twelve cycles (CYCLES 1 to 12) are available for operator custom-
programming of special cycles. Desired cycles values must be prop-
erly set to process accessory racks accordingly.
Cycles include various sequences of phases.
NOTE: See Table 5-1, Cycle Description Chart, for phase specifica-
tions.
IMPORTANT: A listing of the Safety Precautions to be observed when operating this Cage and Rack
Washer can be found in S
ECTION 1. Do not operate equipment until you have become familiar with this
information.
CYCLE AND CONTROL VALUE PROGRAMMING
5