6-11
Routine Maintenance Operator Manual 920509-645
6.5.2 Clean Side Tanks Side tanks must be cleaned once every two months using Manual
Control mode as follows:
1. Press MANUAL touch pad to access Manual Control mode and
display menu of available manual functions.
2. Press DRAIN touch pad to select DRAIN function.
3. A menu screen appears listing chamber sump and other washer
tanks which may be drained using this function.
4. Press ALKALINE TANK or ACID TANK touch pad to begin
draining corresponding tank.
5. Allow tank to drain.
6. Lock disconnect switch in OFF position and close building sup-
ply valves.
7. Open manual drain valve (see Figure 6-4) to allow any remaining
liquids to drain.
8. Lift off tank cover and flush out tank by spraying inside of tank
with a hose. Allow tank to drain and replace tank cover.
9. Close drain valve.
10. Repeat procedure for each tank.
11. Re-energize washer utilities.
• Side tank with guaranteed temperature (option):
Partially drain side tank using Manual Control mode as follows:
1. Press MANUAL touch pad to access Manual Control mode.
2. Press DRAIN touch pad function.
3. A menu screen appears listing chamber sump and other washer
tanks which may be drained using this function.
4. Press COOLDOWN touch pad to begin draining cooldown
(drain discharge) tank.
5. Allow tank to partially drain, then press COOLDOWN touch pad
to stop cooldown tank draining.
6. Lock disconnect switch in OFF position and close building sup-
ply valves.
7. Lift off cover and flush out tank spraying inside of tank with a
hose.
8. Replace tank cover and re-energize washer utilities.
9. Resume draining side tank.
10. When draining is complete, screen returns to drain menu.
11. Press X touch pad to return screen to manual function menu.
12. Press X touch pad to return to Mode Selection screen.
WARNING – ELECTRIC SHOCK
HAZARD:
Disconnect all utili-
ties to washer before servic-
ing. Do not service washer
unless all utilities have been
properly locked out. Always
follow local occupational
health and safety regulations,
as well as electric and plumb-
ing codes.
WARNING – CHEMICAL BURN
AND/OR EYE INJURY HAZ-
ARD
: Washer detergents are
caustic and can cause
adverse effects to exposed
tissues. Do not get in eyes, on
skin or attempt to swallow.
Read and follow precautions
and instructions on detergent
label and in Material Safety
Data Sheet (MSDS) prior to
handling detergent, refilling
detergent container, or servic-
ing detergent injection pump
or lines. Wear appropriate
Personal Protective Equip-
ment (PPE) whenever han-
dling detergent or servicing
detergent injection pump and
lines.
WARNING – BURN HAZARD
:
• Allow unit to cool down
before performing any ser-
vice on mechanical compo-
nents and on piping.
Components and piping
become very hot during
operation.
• Pipes may be extremely
hot.
To Next Page
Loading...
