6-15
Routine Maintenance Operator Manual 920509-645
6.6 Printer Paper Roll
Replacement
1. Press on the dots on printer cover to release latch; pull cover out
towards you to completely disengage cover; and then gently
swing it down 180° until it rests against equipment panel (see
Figure 6-7).
2. Press on the indentation on the right side-wall of paper cover,
gently pull to release, and swing door to the left until it is open
(see Figure 6-8).
3. Cut leading edge of paper roll straight and square with the sides
as shown on Figure 6-9.
4. Mount paper roll on paper-roll-holder, two plastic protrusions
shaped like domes, inside paper compartment. Paper must curl
up as shown (see Figure 6-10). Paper roll core must properly
align with paper-roll-holder. Make sure paper-roll-holder fits
inside paper core and paper roll can turn freely.
5. Hold both edges of paper and insert it straight into paper slot of
printer mechanism. Printer feeds paper automatically.
6. Press FEED Button to get desired length of paper fed through
mechanism. Do not pull paper in either direction through printer
mechanism.
7. Remove take-up spool and insert leading edge of paper into slit
on its shaft. Wrap paper around spool two or three times tightly
and install take-up spool in printer. First make sure that gear on
take-up spool aligns with gear on printer and then press the
other end of shaft so it snaps in on metal frame.
8. Close paper cover and then close front cover.
NOTE: When changing paper roll, note the following:
1 Use a paper that meets printer specifications.
2 Do not use a paper that is glued to core.
3 Do not fold leading edge of paper when you use a new roll.
4) Do not operate the printer without paper or ribbon; this leads to
rapid deterioration of the print head.
5) Do not use any sharp object to remove paper jams.
6) Do not pull on the paper while the printer is printing.
To Next Page
Loading...
