1-2
764332-098
WARNING – CHEMICAL BURN AND/OR EYE INJURY HAZARD:
WARNING – BURN HAZARD:
WARNING – SLIPPING HAZARD:
CAUTION – POSSIBLE EQUIPMENT DAMAGE:
1
Vaseline is a trademark of Chesebrough Pond's Incorporated.
Detergents are caustic and can cause adverse effects to exposed tissues. Do not get in eyes, on skin
or attempt to swallow. Read and follow the precautions and instructions on the detergent label and
in the Material Safety Data Sheet (MSDS) prior to handling the detergent, refilling the detergent
container or servicing the detergent injection pump. Wear appropriate Personal Protective Equip-
ment (PPE) whenever handling the detergent or servicing the detergent injection pump and lines.
Wear appropriate Personal Protective Equipment (PPE) including gloves and eye protection when
using a descaling product. Avoid contact with eyes or skin. If chemical product was swallowed or
in contact with eyes or skin, read and follow precautions and instructions on detergent label and
in Material Safety Data Sheet (MSDS) and seek medical attention immediately.
Wear appropriate Personal Protective Equipment (PPE) when removing clamps and replacing
squeeze tubes. If chemical contacts skin or eyes, immediately flush with running water for at least
10 minutes. If contact was with eyes, seek medical attention.
Allow unit to cool down before performing any service on mechanical components and on piping.
Components and piping become very hot during operation.
Pipes may be extremely hot.
To prevent slips, keep floor dry. Promptly cleanup any spills or drippage. If spills or drippage are
detergents or other chemicals, follow Safety Precautions and handling procedures set forth on
detergent or chemical label and/or Material Safety Data Sheet (MSDS).
Always use a silicone lubricant to lubricate squeeze tubes. Petroleum-based lubricants, such as
Vaseline
®
1
or grease, will cause squeeze tubes to melt.
Use nonabrasive cleaners when cleaning unit. Follow directions on containers and rub in a back-
and-forth motion (in same direction as surface grain). Abrasive cleaners will damage stainless steel.
Cleaners rubbed in a circular motion or applied with a wire brush or steel wool on door and chamber
assemblies can be harmful to stainless steel. Do not use these cleaners on painted surfaces.
Ensure a cooling fan is attached to rear motor shaft. Check that the fan blades are positioned to send
airflow to motor. Motor will overheat without a cooling fan
Carefully tighten setscrew. Metal setscrew can easily strip plastic threads in roller block assembly.
To Next Page
Loading...
