Struers LaboPol-30 - Getting Started; Device Description

CAUTION
When the disc is rotating, make sure your hands are kept completely clear of its
periphery and out of the splash bowl.
WARNING
Do not use the machine with defective safety devices.
Contact Struers Service.
WARNING
Before you release the emergency stop, investigate the reason for activating the
emergency stop and take any necessary corrective action.
CAUTION
To prevent specimens from detaching from the specimen holder, make sure that
the specimen or specimens are clamped securely in the specimen holder.
CAUTION
Protective footwear is recommended when you handle heavy specimen holders.
CRUSHING HAZARD
Keep your hands clear of the specimen holder or specimen mover plate when
lowering the specimen mover.
WARNING
Safety critical components must be replaced after a maximum lifetime of 20 years.
Contact Struers Service.
CRUSHING HAZARD
Take care of your fingers when handling the machine.
Wear safety shoes when handling heavy machinery.
3 Getting started
3.1 Device description
LaboPol-30 is for materialographic preparation (grinding/polishing) using preparation discs of
230, 250 or 300 mm in diameter.
LaboPol-30 is for manual preparation when used with LaboUI.
LaboPol-30 is for semi-automatic preparation when used with LaboForce-50, LaboForce-100 or
LaboForce-Mi. The specimen mover is always installed on the left side of the machine.
3 Getting started
LaboPol-30 13