Struers LaboPol-30 - Operating LaboDoser-10; Changing Lubricant;Suspension

LaboDoser-10 with LaboForce-100
A table stand (optional) is required for using LaboDoser-10
with LaboForce-100.
10.4 Operating LaboDoser-10
The operator adjusts a valve to deliver the required amount of suspension or lubricant on the
preparation disc.
1. Place the dosing nozzle in the optimal position over the preparation disc.
2. Open the valve and adjust the suspension/lubricant dosing level.
3. When the preparation step has been completed, close the valve to stop dosing.
10.5 Changing lubricant/suspension
Struersrecommends using a separate bottle cap for each consumable.
To use the bottle cap with another consumable:
1. Remove the bottle.
2. Hold the bottle firmly and remove the bottle cap.
3. Empty the bottle and fill it with a mild soap solution.
4. Open the valve and clean the dosing nozzle.
5. Exchange the soap water with clean water and repeat the above procedure.
80 LaboPol-30
10 LaboDoser-10