B Distance piece
Note
Make sure to remove the distance piece if you are going to work with mover plates
or regular specimen holders again.
Adjust the horizontal position of the flexible specimen holder
With a flexible specimen holder:
1. Press the Lower/Raise button to lower the
specimen mover head.
2. Loosen the 2 fastening screws holding the
column of the control panel.
3. Place the flexible specimen holder in a
position that does not allow the specimen
to run more than 1 mm over the edge of the
preparation disc.
8.1.8 LaboDoser-100 with LaboForce-100
If you are using LaboDoser-100 with LaboForce-100, see the specific machine manual.
8.1.9 LaboDoser-10 with LaboForce-100
If you are using LaboDoser-10 with LaboForce-100, a table
stand is required.
8 LaboForce-100
LaboPol-30 49
To Next Page