Struers LaboPol-30 - Page 48

Use the flexible specimen holder
1. Place the specimen or specimens on the preparation surface.
2. Press the Lower/Raise button to lower the flexible specimen holder.
3. Make sure that no specimens protrude from the flexible specimen holder. If they
do, adjust the specimens.
– Press the Lower/Raise button to raise the flexible specimen holder.
– Adjust the specimens.
4. Repeat until all specimens are placed correctly.
5. Start the preparation process.
The preparation process stops automatically when the set preparation time has
expired.
6. Clean the flexible specimen holder before the next preparation step.
Adjust the height of the flexible specimen holder
Procedure
1.
2. Attach the distance piece as shown in the illustration below.
A LaboForce-100
B Distance piece
48 LaboPol-30
8 LaboForce-100