• Remove the control panel or specimen mover.
• Remove any accessories.
• Lift the machine by gripping the base of the machine from beneath, from both the left side and
the right side.
• Place the machine and accessories in their original packaging.
• Secure the boxes on a pallet with straps.
At the new location
At the new location, make sure that the facilities required are in place.
5 Installation
5.1 Unpack the machine
Note
We recommend that you keep all original packaging and fittings for future use.
1. Cut the packing tape on the top of the box.
2. Remove the loose parts.
3. Remove the unit from the box.
5.2 Check the packing list
Optional accessories may be included in the packing box.
The packing box contains the following items:
Pcs. Description
1 LaboPol-30
2 Electrical power supply cables
1 Disposable bowl liner, clear plastic
1 Splash guard for manual preparation (for 300 mm disc)
1 Water inlet hose. Diameter: 19 mm/¾". Length: 2 m/6.6'
1 Filter gasket
1 Reduction ring with gasket, ¾" to ½"
1 Water outlet hose. Diameter: 40 mm/1.6". Length: 1.5 m/4.9'
1 Elbow pipe for water outlet
18 LaboPol-30
5 Installation
To Next Page