14 Technical data
14.1 Technical data
Preparation discs Diameter 230 mm (9”), 250 mm (10”),
300 mm (12”)
Rotational speed 50-500 rpm, variable
Spin 600 rpm
Spin (with LaboForce-100) 150/600 rpm
Rotational direction Counter-clockwise
Motor power , continuous,
S1
750 W (1 hp)
Torque (at 300 rpm) >24 Nm(Newton meter)
Safety standards See the Declaration of
Conformity
Operating environment Surrounding temperature 5 - 40°C (41 - 104°F)
Humidity < 85% RH non-condensing
Storage and transport
conditions
Surrounding temperature -20 - 60°C (-4 - 140°F)
Power supply Voltage/frequency 200-240 V/50-60 Hz
Power inlet 1-phase (N+L1+PE) or 2-
phase (L1+L2+PE)
The electrical installation must
comply with Installation
Category II
Power, nominal load 1300 W
Power, idle 16 W
Current, nominal load 5.7 A
Current, maximum load 11.2 A
Current, largest load 5.5 A
Safety Circuit
Categories/Performance
Level
Emergency stop PL c, Category 1
Stop category 0
Residual Current Circuit
Breaker (RCCB)
Type A, 30 mA (or better) is
recommended
14 Technical data
LaboPol-30 97
To Next Page