www.stryker.com 72-1048E MM FL23SE REV A 63
Return To Table of Contents
Note
The shaft of a caster that is part of the braking mechanism must be properly
oriented before mounting it to the base. The opposite illustration shows the
side of the shaft that should be facing the inside of the bed: it is the side
showing the largest opening below the cam in neutral position.
Using the 1/2” combination wrench, remove the bolt and washers (D) 8.
holding the caster to the base.
Note
Before completely tightening the bolt (D), make sure that the caster shaft is completely inserted into the mounting
socket.
Reverse the above steps to install the replacement caster. 9.
If the replacement caster is part of the brake mechanism, apply the brakes and check that the caster is locked 10.
before returning the bed to service.
BED CASTER REPLACEMENT (CONTINUED)
Service Information
To Next Page
Loading...
