Summa S2 CLASS - Page 6

TOC 4
4.2.2.8.2 USB Class ................................................................................. 4-9
4.2.2.8.3 LAN ........................................................................................... 4-9
4.2.2.9 Calibrate X(/Y) ............................................................................. 4-9
4.2.2.10 Coil Setup .................................................................................... 4-9
4.2.2.11 Factory defaults ........................................................................... 4-9
4.2.2.12 Copy current user ...................................................................... 4-10
4.2.2.13 Media Sensor Setup ................................................................... 4-10
4.2.2.14 Calibrate Touch Screen ............................................................. 4-10
4.2.3 Actions .............................................................................................. 4-10
4.2.3.1 Load ........................................................................................... 4-10
4.2.3.2 Reset ......................................................................................... 4-10
4.2.3.3 Replot ........................................................................................ 4-10
4.2.3.4 Cut Sheets ................................................................................. 4-10
4.2.3.5 Open file .................................................................................... 4-10
4.2.3.6 Confidence test .......................................................................... 4-11
4.2.3.7 DIN A4 Test ............................................................................... 4-11
4.2.4 ROM REVISION................................................................................ 4-11
4.2.5 Configuration (Quick parameter change) ........................................... 4-11
4.2.6 Pause (Online/Offline) ....................................................................... 4-11
5 Maintenance and Cleaning ...................................................................... 5-1
5.1 Introduction ..................................................................................... 5-1
5.2 Cleaning the Drive System ............................................................. 5-1
5.3 Cleaning the Media Sensors .......................................................... 5-2
5.4 Cleaning the Y guiding ................................................................... 5-2
5.5 Cleaning the nose piece (tangential machine only) ..................... 5-3
5.6 Cleaning the OPOS system. ........................................................... 5-4
5.7 Changing the fuse ........................................................................... 5-4
6 Error codes ................................................................................................ 6-1
6.1 X-axis error! Overflow or Overcurrent! .......................................... 6-1
6.2 Y-axis error! Overflow or overcurrent! .......................................... 6-1
6.3 Cutter is unable to find the knife home position .......................... 6-2
6.4 Up down encoder not working ....................................................... 6-2
6.5 Unable to lower OPOS .................................................................... 6-3
6.6 OPOS sensing errors ...................................................................... 6-3
6.7 Illegal plot command ....................................................................... 6-4
6.8 Syntax error ..................................................................................... 6-4
6.9 NVRAM failures and messages ...................................................... 6-4
6.10 Internal errors .................................................................................. 6-5
6.11 Upgrade errors and messages ....................................................... 6-5
6.12 RAM ERROR .................................................................................... 6-6