89
CHAPTER
9
Configuring IP Addressing
In order for there to be an out-of-band Ethernet connection between the local
management host and the controller modules, the management host and the
controllers must have valid IP addresses.
This chapter describes how to configure IP addressing on the local management host
and on the controller modules. It contains the following sections:
■ “About IP Addressing” on page 89
■ “Configuring the IP Address of the Controller Modules” on page 89
About IP Addressing
The Sun StorageTek 2500 Series Array is managed out-of-band by way of a standard
Ethernet connection between the controller modules and your management host.
Perform the following procedures to ensure that the local management host and the
controllers have valid IP addresses:
■ Configure IP addresses for the controller modules (see “Configuring the IP
Address of the Controller Modules” on page 89)
■ Configure an IP address for the management host (see the Sun StorageTek Common
Array Manager Software Installation Guide)
Configuring the IP Address of the
Controller Modules
You can configure two types of IP addressing for the Ethernet port of each controller:
To Next Page
Loading...
Need help?
General
