Sun Microsystems 2500 - Appendix C iSCSI Configuration Example Using Windows; To Prepare for the iSCSI Configuration

Appendix A Configuring iSCSI on the Sun StorageTek 2510 Array 99
Configuring iSCSI - Detailed
The following sections detail the steps in planning, cabling, and configuring iSCSI:
■ “Preparing for iSCSI and Installing Hardware” on page 99
■ “Configuring iSCSI Tasks” on page 100
■ “Configuring Other iSCSI Features” on page 104
The first two sections contain tables listing each step in configuring iSCSI:
■ “iSCSI Preparation and Hardware Steps” on page 100
■ “iSCSI Configuration Steps” on page 101
You can use the procedures in conjunction with examples for Solaris and Windows.
For an example of configuring iSCSI on a Solaris host, go to “iSCSI Configuration
Example Using Solaris” on page 107.
For an example of configuring iSCSI on a Windows host, go to “iSCSI Configuration
Example Using Windows” on page 111.
For an example of configuring iSCSI on a Linux host, consult your Linux OS
documentation.
The RDAC driver for LINUX supports the Sun StorageTek 2510 Array. To download:
1. Go to www.sun.com
2. Select Download
3. Select View by Category
4. Select Systems Administration >> Storage Management, and scroll down to the
StorageTek 2500 Series offerings.
Preparing for iSCSI and Installing
Hardware
This section details the steps to prepare for iSCSI and complete the hardware
installation before beginning configuration.